Hot Rod Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
63 Posts
Discussion Starter · #1 ·
I got a ron franses wiring circut pannel,with fuses,hooked indeependent of my reg fuse pannel,to it I hooked up a oil pre luber 12v,and my fuel pump on same circut.it has been workin fine for long time.then both just stoped?they were wired to the ingnition side of pannel.I checked fuse ok.so swiched to wire to the battery side of the pannel? still dead.think could be a ground,but its clean to bare metal and good?any thoughts
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top