Pics of My Transmission Table

6201 Views 5 Replies 5 Participants Last post by oldschoolrods, Nov 29, 2004

iiibdsiil

Discussion Starter · Nov 29, 2004

This is not what I wanted, but it works. I got the table for free, and pops made it work, and put the money into it, so I'm not gonna complain.

I didn't really capture the detail of it, too pissed about the trans that is sitting on top of it. But, he took his time, it came out really nice.

See less See more

Save

1 - 6 of 6 Posts

Kevin45

· #2 · Nov 29, 2004

Pretty nice. Probably better than most you would buy anyhow. Kudos to pop:thumbup:

Save

Canadian Charlie

· #3 · Nov 29, 2004

Great looking table. I could use one of them:thumbup:

Save

Did Pops use some gasket material or silicone between the angle and the table? And does it tilt to the drain? Looks like some good recycling efforts on Pops part !
You DID wash his vehicle for him for building that, right?

Save

iiibdsiil

Discussion Starter · #5 · Nov 29, 2004

Yes, it was like an art table, so it has a built in tilt thingy.

He siliconed the thing all over. He put a sheet of 3/4 ply wood, and then a sheet of galvanized steel on top. Then he siliconed and screwed the almumin angle iron to the top.

It works great.

And no, I didn't wash his car, he was just glad to see me. I live in Tampa, him in Ft. Lauderdale, and my schedule whenever I come down is usually too hectic for anything more than a simple lunch.

Save