Hot Rod Forum banner
1 - 3 of 2 Posts

·
Registered
Joined
·
1,643 Posts
Discussion Starter · #1 ·
hello fellow hot rodders, does anyone know how do i powdercoat frame? cause i know u have to like "bake" it in like 400 degrees for 10 minutes to cure, but how do i "bake" whole frame then? doesnt powdercoating dry after being applied? and what capacity of air compressor should i use if i buy it like from ebay about 3Hp 8 gallons would be enough air pressure for the job?
 

·
Registered
Joined
·
1,643 Posts
Discussion Starter · #3 ·
thanks for reply, it helped me answer some questions, cause i wondered how it "cures"
i had in mind that it was some kind of plastic media that was melted in oven, but u just made me sure
thanks. sandblasting i can do myself though i have my own kit to do that, i guess i will just put some special black frame coating on it, no need for expensive powdercoat,when i can do it cheaper and look as good as powdercoat, but anyways thanks for reply, this board is very helpful
 

·
Registered
Joined
·
1,643 Posts
Discussion Starter · #5 ·
i wondered if i could very carefully "cure" it with butane torch going very carefully so it wont burn but just heat it up enough to mold onto parts..?
 
1 - 3 of 2 Posts
Top