Hot Rod Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
54 Posts
Discussion Starter · #1 ·
So I have a long style water pump on my SBC. When I installed my engine, I switched to headers. I ordered a SBC bracket for power steering, but it seems like o have a different pump then pictured? Can anyone explain what I have and where I can find a bracket? As you can see on the back side of the pump, I only have 1 stud. All the directions for different brackets I keep seeing have 2 threaded portions on the back side of the pump. I'm so confused.
 

Attachments

·
Registered
Joined
·
399 Posts
take some picts of the brackets.. you should have a front one and a back on that the studs goes through they should bolt together and the pump will move on the stud for belt adjustment
 

·
Registered
Joined
·
4,709 Posts
I don't know if these will help out or not but I have a bracket setup I have yet to install but its identical on the bottom part like the one you posted and hope these photos can help you out.
Motor vehicle Automotive tire Wheel Automotive design Vehicle
Font Newspaper Monochrome photography Art Paper
Motor vehicle Automotive tire Gas Bicycle part Auto part
Wheel Automotive lighting Automotive tire Plant Locking hubs
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top