Rearend

717 Views 3 Replies 2 Participants Last post by Deuce, Nov 30, 2004

34KEN

Discussion Starter · Nov 28, 2004

BUILDING 34 FORD COUPE NEED TO KNOW WIDTH OF REAR-END
FROM BACKING PLATE TO BACKING PLATE OR FLANGE OR AXLE FLANGE WILL BE USING BUGGY SPRING AND LINKS A PICTURE WOULD ALSO BE GREAT

Save

1 - 4 of 4 Posts

Quit shouting.................or take the caps lock off.

Most folks use a 57 to 59 Ford 9 inch rear. They are 58 inches wide ( measured from the wheel mounting flange to the wheel mounting flange )

http://www.dfwmotorsport.com/Fairlane/9inchrearends.htm

is a site to check out

Save

34KEN

Discussion Starter · #3 · Nov 29, 2004

sorry forgot about the caps being on , great info , thanks next question will this have the tire close to body

Save

Deuce

· #4 · Nov 30, 2004

34KEN said:
sorry forgot about the caps being on , great info , thanks next question will this have the tire close to body

Depends on the offset of the rims you choose. With a standard 15X7 rim with O offset.........the wheels and tires will be under the fender........wheels are available with different offsets

so you have to choose........

.

Save

1 - 4 of 4 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month