Hot Rod Forum banner
1 - 3 of 3 Posts

·
1969 Mustang Coupe Project Car
Joined
·
1,238 Posts
Discussion Starter · #1 ·
This may sound dumb but here goes. The previous owner removed the XJ6 logo from the back of my Jag, they filled in the holes and repainted. I was thinking of putting them back on but some of the filled holes are not accessable due to double walling in trunk (boot in england) area. Whats the best way to restore them.

Thanks
Mark
:D
 

·
Banned
Joined
·
431 Posts
normally if you go and buy new ones they come with a type of push in clip, and you woundn't have to worry about trunk acess because they push in from the front, but i don't know how yours go on it might be different. the other thing is just finding out where they were and drilling the correct holes.
 

·
Registered
Joined
·
369 Posts
One way to do this is grind the guide pins off the use double sided tape for side molding's that they sell at any auto parts store. That's what they use on new cars and dealerships logos.
 
1 - 3 of 3 Posts
Top