Hot Rod Forum banner
1 - 1 of 6 Posts

· Registered
3,265 Posts
Axle, not to difficult if you can weld, and...well.. you can so lets get to it.

Just try to finf the same size channel used on the frame cut off the exsisting sheeter peice weld the new peche on, grind down the wlds and box over the weld on both sides with some 3/8-1/2" steel and your good to go.

On a side note those quadra port '63's make cool low blow sleds. Add some 17" wheels and lower it and its totally beechin maaan. :cool:

1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.