Hot Rod Forum banner
1 - 1 of 6 Posts

· you're killin me buck!
449 Posts
Discussion Starter · #1 ·
my boss has a 63 four door impala sitting in a grass lot . he say's he wants to sell it.
i would like to make a sled out of it.
it needs a small hunk of frame replaced ( less than a foot) behind the curve over the rear axle.
i have done all kinds of welding, and the rest of the car is pretty straight.
my question is weather one can sucessfuly replace a section of frame, and the best way to go about it.
axle bastard
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.