Hot Rod Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Now that I have your attention....I'm Heath. Just joined the site and look forward to interacting with members and learn new tricks and tips and share some I may have up my sleeve.

About to undertake a Ford FE build. Thinking on going with a 410cid (390 block x 428 crank). Does anyone have a build for one? I'm looking for the 525 to 550 HP range and will run an aluminum top end, cast bottom.

Not adverse to a possible stroker build, as long as it is on an FE platform.

Thanks in advance for any assistance or directions.

Heath
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top