Hot Rod Forum banner
1 - 1 of 1 Posts

·
New to the Hobby
Joined
·
12 Posts
Discussion Starter · #1 ·
I'm trying to adjust the idle which is too high (about 1400 rpm). I can't get the idle lower than 1400.

There is barely an 1/8 turn between 1400 rpm and 0 rpm. As I close the screws this last bit, it simply dies. I have to back the screws out 1/8 in order for the engine to run again, and when I do - its 1400 rpm again.

Any thoughts?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top