[dave350v8]

Hi Guys
Finally got around to removing my camel humps,replacing them with some aluminium heads 64cc 210 runners,my cam is a 280 magnum 480 480 lift,would I benefit from replacing 1:5 rockers with some 1:6 rockers(resulting in a 510 510 lift)I was told the 210cc runners are too big for my setup?
+60 sbc,rpm intake,flat tops,600 holley.
Any imput would be great?

 

[327NUT]

Totally up to you but unless you're racing around your streets at 6,000 rpm you'll never notice the difference.

 

[dave350v8]

Thanks for your replies,think I will run it down the strip see how it performs,hopefully runs quicker than the camel humps! May look at swapping the cam then,just bought some howards retro roller lifters for a future build! so i might use them with a good roller cam. always felt that the camels were holding back on the top end,or the 600 hollley. Thanks F-BIRD for your detailed advice!