Hot Rod Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
149 Posts
Discussion Starter #1 (Edited)

·
Premium Member
Joined
·
2,370 Posts
Well we kinda need to know what heads you have to answer this question.

If you can use roller rocker . . use them . . . better than the ol' stamped sort.
 

·
Banned
Joined
·
3,532 Posts
Your springs should handle it, but new springs are always a plus. Check that your pushrods clear the pushrod slots. With 1.6 rockers and higher lifts, they might not clear. You are probably okay.
 

·
Registered
Joined
·
2,240 Posts
You also need to think about your rocker studs, if they are pressed in (which is probably the case with stock heads). The 1.6 rockers will put a little more "stress" on them. Might not be enough to worry about, just something to keep in mind.

Royce
 
1 - 5 of 5 Posts
Top