Hot Rod Forum banner
1 - 1 of 6 Posts

· Registered
623 Posts
Whenever I encounter rust pitting I blast and apply a rust inhibitor/neutralizer as the above state. However if the pits corrupt the integrity of the metal; they are deep enough to weaken, soft when pressed w/screwdriver, or any holes through- I will cut out the entire panel and replace. Better to be sure than to have to do it again. Good luck!
1 - 1 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.