Hot Rod Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter #1
Hi there,

I'm new to the board. I've recently done a frame-up restoration of a 1989 Chevy S-10 Durango with a 4.3L TBI. It's been on the road for a week, & I'm still working out a few bugs. One of which is the cruise control. The unit that was in the truck has the servo & controller as one unit. Right now, it won't do a thing. When I tore it down, I was pretty meticulous when marking wires, etc. but I have a blue wire from the servo that I have no idea if it is even used. I have a Hanes manual, but the wiring diagram shows the servo/controller as two units, so the wiring doesn't make sense. I've been searching for the right wiring diagram with no luck. Does anyone out there have such a diagram??

Thanks,

Roddin Rob.
 

·
Registered
Joined
·
1,192 Posts
Hello and welcome to the board:welcome:

you might wanna try posting that question in the electrical forum of the board......you'll get way more responses there.





Mike
 
1 - 2 of 2 Posts
Top