Hot Rod Forum banner

S10 rack and pinion steering

1743 22
So this is not going to work.

Tire Wheel Hood Automotive tire Car

I thought I could adjust it so it would not be "that bad".

But it is just going to have to much bump steer even adding a idler etc.

So it is all getting ripped out and starting fresh.

This is a 94 s10 frame stock control arm G body spindles. The frontend has around 800lbs of sprung weight. This has around a 60% rear bias.

I am thinking a pinto rack off rock auto(something easy to replace) then make my own mounts and links.

But I also dont want to run into a bump steer. Also I dont know which rack will even get me close.

Any one have recomendations on what works? Perferably something you installed on a s10 frame.
1 - 1 of 1 Posts
1 - 1 of 1 Posts