Hot Rod Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter · #1 · (Edited)
i have a 79 cheve luv 4x4 1.8 liter Isuzu's the timming chain guide went out thin the auto matic tenneser fowled so i pulled the moter out to replace the chain but in the process the wire for the altenator touched the frame and arked so i replaced the fuse and i have no power any where is any in line fuses i need to know about all the help i can get would be grateful
 

·
Lost in the 60's
Joined
·
15,292 Posts
Welcome to Hotrodders....This is the Introduction forum so you should post your question in the Electrical forum.....there is a guy there by the name of Doc Vette...he can get you going. Sounds like you blew a fusible link...should be one where the big wire that feeds the fuse block connects to the starter solenoid.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top