Hot Rod Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
I have a 350 thats out of a 77 c10 or 20 its a 010 block. its a 4 bolt. its a short block right now(it was free too!!!). I was thinking maybe a blown 383 but not quite sure yet. i want to go with the 383 but keeping it a 350 may be cheaper right now. any ideas for a rotating assembly, cam, heads, and what kind of slugs should i run? i also want to go full roller but not sure yet. any help would be greatly appreciated!
thanks
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top