Hot Rod Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 ·
Hi guy. Im restoring my old 77 k10. I replaced the gas tank years ago when i bought the truck. The gas gauge wasnt working at the time. I found the ground wire was broken so i fixed that when i changed out the tank. The problem is when the fuel gets down to about 3/4 to 1/2 the gauge starts bouncing all over the place as the truck is moving. Any thoughts. I would like to fix it while i have the cab off the frame. Thanks for any help.... Sam
 

·
Registered
Joined
·
9 Posts
Discussion Starter · #3 ·
Thanks for the info. If there is loose wires in the sending unit is that fixable or must the whole sending unit be replaced. Thanks again...sam
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top