Hot Rod Forum banner
1 - 4 of 4 Posts

·
Premium Member
Joined
·
6,735 Posts
Change the needle and see what happens. Sometimes it will get slightly bent and hit the opening on the foot.
 

·
Registered
Joined
·
346 Posts
Discussion Starter · #3 ·
I installed aa new needle and oiled the machine and seems the problem is gone. I have one question. Is the oil well below bobbin supposed to remain full of oil? Could not find any guidance in the manual
 

·
Premium Member
Joined
·
6,735 Posts
The Consew 226 is not self oiling, so there really is no oil well below the bobbin. Just put a couple drops of oil next to the bobbin, and it will end up where it needs to go.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top