Hot Rod Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
86 Posts
Discussion Starter · #1 ·
I recently purchased a set of 37-48 Ford spindles from speedway motors. When I took them to the machine shop, the machinist observed them to be defective (not seating right on the axle/ground down un even). Has anyone had an issue with them before? Is speedway motors pretty good about replacing them? Thanks!
 

·
Registered
Joined
·
559 Posts
1937MoPar said:
I recently purchased a set of 37-48 Ford spindles from speedway motors. When I took them to the machine shop, the machinist observed them to be defective (not seating right on the axle/ground down un even). Has anyone had an issue with them before? Is speedway motors pretty good about replacing them? Thanks!
Speedway is terrific, in my opinion, to deal with. I always work with Brian Robinson up there.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top