Hot Rod Forum banner
1 - 1 of 23 Posts

· Registered
4,244 Posts
I just did my S-10 with Duplicolor Bed Coating Material. I got it at WalMart for $35 a gallon. I used a $15 syphon feed blow gun and it turned out beautifully. It is a really good hard material and it lays down nice. I did thin it a bit to about 4 to 1 with H.E.T. so it would lay down a little bit wetter for a smoother finish.

Make sure you scuff the bed before doing this. I worked mine over top to bottom with some 80 grit and a disk sander. If you skip this huge pain in the *** step, it will not last long.

1 - 1 of 23 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.