Hot Rod Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
328 Posts
Discussion Starter · #1 · (Edited)
I have a stock 74 350 sbc,looking to make a good street motor.Would like input on size of cam and heads to use,the car its going into is a 81 trans am with 2.56 gear ratio.Thanks all in advance.Sorry about the duplicate post can someone please delete.
 

·
Banned
Joined
·
1,971 Posts
wow you definitely need to lose that 2.56 if you want any decent acceleration

just changing that to a 3.73 etc will alone make for a much quicker car

youve got a heavier car so i wouldnt go with a crazy cam and would go with one for more of a low end torque output

because i dont think youre going to go to the track and run high RPM all the time


good luck
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top