Hot Rod Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
350 turbo rebuild at a shop 4 yrs ago. Let it set around till car was ready. Trans got a shift kit and myself and a couple buddies stabed the converter.2500 stall. Got the wireing done and the car started and ready to roll. *** it wont go into gear. I rev it up and it tries to go a little in drive and Reverse. Did I stab the converter wrong and burn up the pump. Or could there still be hope? :spank:
 

·
Build it right the first time
Joined
·
227 Posts
yeah you deffinatly need to make sure you filled up the torque converter with fluid at least 8 quarts for sure, and with it being a stall, its gonna need more gas to get it rolling.........and make sure you filled the rest of the tranny up as well......
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top