Hot Rod Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
95 Posts
Discussion Starter · #1 ·
Well I have a long tail t350, that as I was mounting my original shift linkage from a 91 3.1 camaro and doing so I managed to break the bolt holes that hold the linkage to the transmission. In the pic is where my holes were.

Has anyone done this before and found a remedy for it, or is it pretty well toast?
 

Attachments

·
Registered
Joined
·
95 Posts
Discussion Starter · #3 ·
Unfortunately broke. The only part that left to it is the bottom half. Is it possible to mold jb weld into its own shape, like the top rounded half, then tap into there? Or would it even hold up very well.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top