Hot Rod Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
Finally I can talk with other hot rodders!!!!

I just got married and moved into my new house, and hooked up my wifes computer. I'm currently building a 1952 chevy that was a four door stocker but now i've shortened to a 2 door, did a 6" chop on it as well as a body drop. one problem, I now have too make floors for it but don't know the safest way to mount the support bars to the body any help would be greatly appreciated.
 

·
Registered
Joined
·
654 Posts
Welcome, congratulations on the marriage , new house and project. Sounds like you have a major one going on there. There might well be post's already covering floor replacement here but I haven't searched. Here is a floor replacement going on http://www.commerce.usask.ca/staff/hipkin/burb/interior.html

It is a different vehicle but the same principles would apply.

Good luck with your project and have fun.
 

·
Registered
Joined
·
8 Posts
Discussion Starter · #3 ·
Thank you

How cool is that!

The site you guided me to is also using an S10 frame like I am but forget to add. Therefore the mounting points are all the same.

Thanks again!!!
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top