Hot Rod Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Getting ready to re-do my 52 Chevy Pickup. Where can I get a Fiberglass tilt front end. Looking for one closer than US Body in FL. It appears from the messages that I've got my work cut out for me. Is it typical or common sense for a tilt front end not to have fender wells? Anxious in PHX.
 

·
Registered
Joined
·
41 Posts
Most of them I have saw have no inner fenderwells, and in my opinion you have your work cut out for you, good luck, I would like to see a picture when you get her finished
 

·
Registered
Joined
·
4,259 Posts
You're correct. Typically inner fenders are not used on tilt front ends. That doesn't mean you can't do it, just that it makes the job quite a bit more difficult and the front end heavier.

Centerline
<a href="http://www.hotrodsandhemis.com" target="_blank">http://www.hotrodsandhemis.com</A>
 

·
Registered
Joined
·
102 Posts
Be prepared for alot of work if you are going to install a glass nose on your truck. These noses rarely fit correctly when you purchase them. I have one on my F1 from Fairlane and it has taken alot of reworking to get it to fit properly. I still haven't worked all the "bugs"out of it yet.
 
1 - 4 of 4 Posts
Top