Hot Rod Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter · #1 ·
I want to build a top thing for my toolbox. Its hard to explain
but it would be a top box with a flip up door.
I would put a pegboard inside it. Would anyone know if there
might be plans for this on the net?
I can weld and have a welder i just need some direction.
Thank you.
 

·
Hotrodders.com moderator
Joined
·
9,581 Posts
Drawing?

Linda,

Can you make a sketch of this? even using a sharpie on a napkin is a good place to start..Once the idea is commited to paper then it can be dimensioned and then fabrication can commence..:thumbup:

OMT
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top