Hot Rod Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
146 Posts
Discussion Starter · #1 ·
Can someone tell me how much torque requirements
for the 5 bolts from pulley to harmonic balancer
and the the torque on water pump to engine.

Thanks

Marcus
 

·
Come Home Safe Soldier
Joined
·
846 Posts
I just draw the pulley to balancer bolts tight,then do the same with the balancer/crank bolt.I have a certified torque elbow though,plus a certified Eyecrometer!:thumbup:
 

·
Registered
Joined
·
2,240 Posts
OK, the specs are as follows. 3 outer bolts 25lft bs and the center bolt to 60ft lbs.

Royce
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top