[chewyscool]

I have noticed the last 2 times I have started my car and put it in reverse it Hardly pulls, when before you need not give it a gas and you could back right up. Also in drive same condition. If I do give it some gas it will move as it used to. I have a 700r4 and a 2400 stall. Shows good on fluid when warm but the stick is hard to read though. This has been running only 500 miles so far. Any thoughts.

 

[SSedan64]

TV cable connected and adjusted correctly?? You're not comparing before with stock converter and after with 2400 stall converter, are you??
Low & Reverse have higher pressure than other gears so something is not right.

 

[chewyscool]

TV cable connected and adjusted correctly?? You're not comparing before with stock converter and after with 2400 stall converter, are you??
Low & Reverse have higher pressure than other gears so something is not right.

No since 0 miles to present, tv cable has not moved for its working point.

 

[SSedan64]

You need to hook up a pressure gauge. Port just above the shift lever shaft. Pressure Info at bottom of this page applies to the 700R4 also. > http://www.extremeautomatics.com/techinfo.html
TCI's pressure #'s >> http://www.tciauto.com/Products/TechInfo/line_pressure.asp#TH200700

 

[chewyscool]

Thanks for the info, I'll give it a shot and see what I come up with. :thumbup: