Hot Rod Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
654 Posts
Yes, I remember your truck and the ball joint. Did the person who repaired it by chance remove the control arm and fail to reattach it properly? Usually that wouldn't be done for a ball joint replacement but you never know.

I'd look the control arm, brake components and flex hose over closely for damage. The control arm will probably be OK if it wasn't bent. Install new bolts and torque to specifications. Then get a front end alignment. Doing this in a heated shop wouldn't be a big deal. In the snow at those low temperatures it will be a pain.

Good luck and don't freeze.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top