Hot Rod Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1,527 Posts
Discussion Starter · #1 ·
I've had a set of these offered to me for $450 bare. Does anyone here know if they use standard length valves? I checked Worlds website and downloaded the pdf catalog but they don't list this particular spec.

I e-mailed them but sometimes it takes a few days for them to reply. Does anyone here know for sure?

Larry
 

·
Registered
Joined
·
570 Posts
Say,just for your info,I bought a pair of those bare a couple years back,they were the angle plug 64 cc ones. I had to do a lot of work on the chambers to make em nice,the seats were cut and didn't match well,took a lot of blending,I wasn't happy. They turned out real nice,but ended up at 68 cc when I was done,just so you know.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top