Hot Rod Forum banner
Cancel

Vortec-like heads with Gen I holes

781 Views 2 Replies 2 Participants Last post by  Yardstick, 
Y
Are there any heads for a Gen I motor (I think it's Gen I -1975 Chevy truck motor) that are close to Vortec heads, but with perimeter valve cover holes and the old intake manifold hole angle? I know I could switch to actual Vortec heads, but I've got the Edelbrock EFI setup for the Gen I heads and don't want to have to buy a whole new manifold.
Reply
Save
Like
1 - 3 of 3 Posts
engineczar
The Dart Iron Eagles are somewhat similar. They also have a heart shaped chamber and can take early style intakes and valve covers. RHS sells a Vortec with dual intake bolt patterns but not perimeter valve covers.
Reply
Save
Like
Y
I wish I would have found this place and asked that question long ago! That was fast. Thanks!
Reply
Save
Like
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Hot Rod Forum
A forum community dedicated to hot rod owners and enthusiasts. Come join the discussion about restoration, builds, performance, modifications, classifieds, troubleshooting, maintenance, and more!
Full Forum Listing
Explore Our Forums
Engine Hotrodders' Lounge Body - Exterior Transmission - Rearend Hotrodding Basics
Top