Hot Rod Forum banner
1 - 2 of 1 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter · #1 ·
I'm pretty much done cutting out the rust in my car. What do you guys know about weld-through primer? Should I use it on my floorboards? I know I'm going to have to overlap some spots because I'm not the greatest welder in the world, and I'm afraid of messing up if I do butt welds. Also, all I have access to is a wire feed welder. Will that do the job? Thank you very much! So far, owning the Rambler has been one of my greatest experiences. I got it running and took it for a short ride. It's got tranny problems, it rattles, squeaks, and makes strange sounds, and I can smell gas when I drive it, but I love the thing to death. Now I know why you people do what you do. Thanks again!
-Levi
 

·
Registered
Joined
·
22 Posts
Discussion Starter · #5 ·
The tank is dropped and all the gas lines removed. That was the first problem w/ the car. Sediment went through the lines and killed the fuel pump, so I restored the tank and we used a temporary one to get the car to the shop. What is the difference between a MIG and a regular wire feed?
-Levi
 
1 - 2 of 1 Posts
Top