Hot Rod Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
20 Posts
Discussion Starter · #1 ·
OK I used HB primer and sanded to 320 then shot 2 coats of sealer. Now I need to wet sand with 600 before I shoot Base. ? Do I block the 600 or use my little 3m sponge that I use to wet sand the clear? I have always shot the sealer wet on wet but wanted to go the extra step on my own car.
 

·
Registered
Joined
·
1,056 Posts
When I wet sand my sealer I just use a peice of used 400 grit and hand sand it very lightly. Seams to work fine for me. By the time your in sealer you shouldn't need to be doing any more block sanding. That should have already been done with your 2-k primer.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top