[JMEDLEY001]

I hAVE 750 EDEL. ON A SBC BORED 60 OVER W/7101 @ 7102
INT @ CAM KIT. I WOULD LIKE TO KNOW WITCH METERING RODS @ JETS TO USE FOR BETTER GAS MILEAGE @ PERFORMANCE. ANY @ ALL SUGGESTIONS COMENTS :welcome: :welcome:


AS ALWAYS HOTRODDERS BB IS :thumbup: :thumbup:




JIM DANDY

 

[DoubleVision]

Without knowing the entire combo and where you are sea level wise, there`s no way to guess what metering rods to use, even if we had all that information, it`ll still be a ball park figure, you`ll have to experiment until you find the right ones. Almost every engines fuel demand is different.

 

[techinspector1]

Follow the instructions in the Edelbrock Owner's Manual and you can dial it right in.......

http://www.edelbrock.com/automotive/eps_intro.html

 

[cboy]

As you will note in Edelbrocks tuning manual, it is a combination of jets, rods AND return springs...along with possible adjustments to the accelerator pump. One of the best (but most expensive) ways to proceed is to buy Edelbrocks complete tune up set...which contains all rods etc. Otherwise, if your setup is already running fairly decent and you just need to fine tune a bit, you can buy the springs (I'd buy the entire set since the cost is minimal) and then just a rod and jet on each side of your current sizes.

But as noted above, start with Edelbrocks manual.

 

[JMEDLEY001]

Follow the instructions in the Edelbrock Owner's Manual and you can dial it right in.......

http://www.edelbrock.com/automotive/eps_intro.html

(Tech in Spector) I apreaciate you ,double v @ CBOY I pulled up the above web site and found exactly what I kneeeded to know.

As always hotrodders BB is :thumbup: :thumbup:


jim dandy