Hot Rod Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
135 Posts
Discussion Starter · #1 ·
Hello All,

I have a Finishline III gun with a 1.5 and 1.8 tip, and a GFG-670+ gun with 1.2, 1.3, and 1.4 tips. For shooting door jambs in either base/clear or single stage urethane should I get the 1.0 tip for the 670+ (i.e. that is the smallest tip they make for that gun, and the smallest tip for the Finishline III is a 1.3) or would the 1.2 be nearly the same? I know some folks use detail guns for these areas, but I just assume not buy yet another gun (heck, I'm new and haven't used any of these yet!). Beyond the physical size of the gun/paint canister is there any difference between a "detail" gun with a 1.0 tip, and a full size gun with a 1.0 tip?

Thanks,

Chris
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top