Hot Rod Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
541 Posts
Discussion Starter · #1 ·
I have a real dumb question. I have a narrowed 9" Ford assembly, in my project car, that has Moser axles. I am needing to put in longer wheel studs, as I am contemplating using 1" wheel spacers. I have Bassett wheels that use a 45 degree lug nut, which is 3/4" tall. Problem is, my current studs, that are 1/2", screw in type are 1-7/8" long from the end to the bottom of the boss to screw them in. I am best guessing that I will need a 4" stud. I cannot find anyone who carries a 4" long, screw in stud, even Moser, Speedway, etc. Any suggestions?
 

·
Registered
Joined
·
541 Posts
Discussion Starter · #3 ·
Why 4"??

1-7/8" works now, but want to add 1" spacer....so add 1" more stud, making it 2-7/8" to 3" long.

A bunch of choices there if it is a screw-in stud betwee 2.5" and 3", ARP even has a 3.470"
You know, I must have been having a brain fade. Your right, if my lug nut works fine on the wheel now, then 3" ought to work fine
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top