Hot Rod Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
34 Posts
Discussion Starter #1
1984 hevy Camaro Z 28
305 700r4 Quadra jet Carb
I just got done putting PCV Valves in it now it accually stays running but now it shifts hard and shakes when giving it gas. When I let up it doesn't shake at all. I have removed all emissions equipment and A/C due to it not working. The PCV holes were just open no valves in them so I put some in and ran it to the Carb. It has been running like crap every since I put the new dist cap, rotor, and coil on. Please help me.
 

·
Registered
Joined
·
34 Posts
Discussion Starter #3
No when I changed the cap and rotor I moved the wires one by one so I did mess it up to bad but I will check real quick.
 

·
Registered
Joined
·
223 Posts
i had this same problem friday night, what happen to mine was my roller rocker arm came complety off, no damage at all. just put it back on , adjusted all of them.
 

·
Registered
Joined
·
34 Posts
Discussion Starter #8
kuhn-77 said:
are any of your plug wires crossed or on the wrong terminal?
Just wanted to say thanks I went to check on that and found that the firing order was wrong that god for the haines manual. not only that but the number four cylinder wire was in two pieces. Runs better now for the timing hain and gear. Once again thanks you guys here are the best.
 
1 - 8 of 8 Posts
Top