Hot Rod Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
806 Posts
Discussion Starter #1
Hey guys, I'm going to school here in about a week for diesel mechanics and on my tool list it calls for a 13/16ths diameter brass punch... I've looked every where and cannot find that size, harbor freight had the smaller ones but no luck finding that size. Any help would be appreciated. :thumbup:
 

·
Come Home Safe Soldier
Joined
·
846 Posts
Contact Snap-On,Cornwell,Matco,MAC.You can order online from any of these dealers,or find the tool man in your area.
 

·
or Jeff, or Doc, or...
Joined
·
989 Posts
Or make your own ! Buy a 7/8" brass rod and have it turned down. (Or start sanding!) My bet is that it will be much cheaper! Brass isn't cheap to start with, but buying a machined piece won't be either. You can look in the yellowpages.
 

·
Super Moderator
Joined
·
6,623 Posts
I make my own out of bar stock from aluminum bronze, better than plain brass anyday and last longer.
 
1 - 6 of 6 Posts
Top