Hot Rod Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter · #1 ·
Need to get baked-on intake (EGR port) gaskets off of small block Ford heads, still on the car or I'd take 'em to a shop and have it done in 2 minutes with an angle die grinder but all I have access to here is a drill w/ a coarse wire wheel. Can i used that to get the baked on gasket off of the heads without damaging it?

The wire wheel is brass.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top