Hot Rod Forum banner
21 - 27 of 27 Posts
you don't need anything in the rain... heck with 93 Saturn I had I could spin the dry/rain tires through third... on aftermarket 16x8 rims :) . In the dry... 4000rpm clutch drop resulted in a minor chiiirp even with the wheels turned. :(
 
spinn said:
i used a foot controlled bellows washer pump, ran the hoses in the trunk. the lines dumped over the rear tires. used water and bleach.

later i went to trans fluid into the exhaust for a smoke screen.

then a auto loc flame thrower kit. exhaust gases cut with a tiny amount of propane.

never did the line lock.
OK ... Your stuff is "WAY KEWL", but ...
Your response to one of my suggestions in a recent post
spinn said:
gear drives are retarded , scratch that.
Maybe I'm just having a bad day, but that sounds pretty hypocritical to me. Do you have the LED "ricer" exhaust tips, too? :rolleyes:
 
I made a system like this with an aftermarket windshield washer bottle and pump. Only problem is as soon as I hit the pump button it empties the bottle even after letting off button because it continues to siphon out as the sprayers are lower than the bottle. Is there some kind of a inline pressure valve I could run that would require the pump to be pumping in order for water to come out sprayers?
 
Thanks 36 Sedan! That's exactly what I was trying to find, only concern is with 1psi cracking pressure...Not well versed with these fittings but not sure if the force from already flowing from pump would be enough to keep it open and allow it to continue to siphon. Worth a shot and cant find anything that small with a higher cracking pressure....Thanks again for reply 36.
 
21 - 27 of 27 Posts